Programming clean remote12/20/2023 READ ALSO: How To Delete Depop Account Trouble Shooting If you are unable to change channels repeat Step Test the remote by turning channels to ensure it works properly.Once your TV turns to a new channel immediately remove your finger from the ” button the code automatically locks in. The LED will blink once and then after 7 seconds it will initiate code The LED will continue to blink every 2 seconds. While pointing the remote at the set top box press and firmly HOLD down the ” button, do not release.With your TV on turn your TV to Channel 3.If volume works correctly move to STEP 3.ĭo You Need A PC For A Monitor? Step 3: Program to Set Top Box Turn TV Test the VOLUME to ensure it works properly.Once your TV shuts off immediately remove your finger from the SETUP button the code automatically locks in. ![]() Press and firmly HOLD down the SETUP button, do not release.Turn on your TV and then stand back approximately 3-5 feet and point the remote at the CENTER of the front.If LED doesn’t light, then the batteries are either in wrong or the batteries are bad. Test Remote by pressing the power button the LED should light indicating that the batteries are in.Close cover with keypad facing away from you by pressing downward (phot C, Step 1) and sliding it toward the front until it is (photo C, Step 2).Insert two AAA batteries into the remote as shown below in photo. ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |